Welltech SPCI2S Intel NetStructure SS7 Boards Manual de usuario descargar pdf (Pagina 48)

SS7 Programmer’s Manual for SPCI2, SPCI4 and CPM8 Issue 2 Page 48

flags

This field is a 16 bit field containing run-time configuration options for the route

as follows:

Bit 0 is set to 1 to indicate that a second link set is contained within the

message. If zero the second_ls field is ignored.

Bit 1 is used to determine whether or not to load share messages across the

two link sets. It is only used when two link sets are specified for the route.

When set the MTP3 module will load share messages for the destination

equally across each of the two specified link sets. Otherwise the MTP3 module

will consider the normal link set to be the preferred link set and will only use the

second link set in the event of failure of the normal link set. The bit should be

set to 1 to enable load sharing across the two link sets or zero to disable load

sharing and use preferred and secondary link sets.

All other bits are reserved for future use and must be set to zero.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 106 107

Sin comentarios

Welltech SPCI2S Intel NetStructure SS7 Boards Manual de usuario Pagina 48