Welltech FXSO Gateway In SIP V.1.2 Manual de usuario descargar pdf (Pagina 77)

FXSO SIP Gateway User Manual Document Ver.: 102

Released Dec., 2004

-add add a routing rule in routing table. User can add less than 50

rules. (route –add prefix “prefix number” dst “destination

port type” e164 “SIP number of port” min “minimum

digits needed” max “maximum digits can’t be

exceeded”)

-delete delete a routing rule in routing table (route –delete “index of

routing rule”)

-modify modify a routing rule in routing table. (route –modify “index

of routing rule” prefix “prefix number” dst “destination

port type” e164 “SIP number of port” min “minimum

digits needed” max “maximum digits can’t be

exceeded”)

-ip create routing table for incoming call from IP side. (route –ip

dst “destination port type” e164 “SIP number of port”)

-fxs create routing table for incoming call from FXS TELs.

(route –fxs dst “destination port type” e164 “SIP number

of port”)

-fxo create routing table for incoming call from FXO Lines.

(route –fxo dst “destination port type” e164 “SIPnumber

of port”)

prefix prefix of dialed number

dst destination port, 0 means FXS TELs, 1 means FXO Lines, 2

means IP side, x means no determinate number.

e164 destination SIP number. This only need to be set when routed

port is FXS TELs or FXO Lines to determine which port will

this call be routed to.

min minimum digits needed.

max maximum digits needed.

hunt set hunt method for busy forward. 0 means no hunting, 1

means hunting method follows the rule of [line], 2 means

hunting method is to hunt between all ports in the same type,

for example, destination port is FXS TEL will hunt in all FXS

TELs, destination port is FXO Lines will hunt in all FXO Lines.

Usage Example:

1. route –add prefix 100 dst 0 e164 1001 min 1 max 3 hunt 1

This command means if gateway has incoming call’s prefix number is

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 99 100

Sin comentarios

Welltech FXSO Gateway In SIP V.1.2 Manual de usuario Pagina 77